External Links

    Journal: IJMMME

    Volume 6, Issue 4

    1 -- 10Rajeev Ranjan. Dynamic Behaviour and Crack Detection of a Multi Cracked Rotating Shaft using Adaptive Neuro-Fuzzy-Inference System: Vibration Analysis of Multi Cracked Rotating Shaft
    11 -- 29Abhijeet Vithal Marathe, Neelkanth V. Marathe, G. Venkatachalam. Angular Torque Methodology for Cylinder Head Bolted Joint and Validation by FE and Experimental Work
    30 -- 47M. Santhanakumar, R. Adalarasan, M. Rajmohan. An Investigation in Abrasive Waterjet Cutting of Al6061/SiC/Al2O3 Composite Using Principal Component Based Response Surface Methodology
    48 -- 62Shailesh Dhomne, Ashish M. Mahalle. Parameter Optimization of Thermal Barrier Coatings used in Two Stoke Externally Scavenged S.I. Engine using Non-Traditional Optimization Algorithms

    Volume 6, Issue 3

    1 -- 10Amneesh Singla, Rajnish Garg, Mukesh Saxena. Effect of Heat Treatment on Microstructure and Tensile Properties of A356/V2O5 Insitu Composites
    11 -- 27Sumit Bhowmik, Prasanta Sahoo, Sanjib Kumar Acharyya, Sankar Dhar, Jayanta Chattopadhyay. Effect of Microstructure Degradation on Fracture Toughness of 20MnMoNi55 Steel in DBT Region
    28 -- 44Nupur Goyal, Mangey Ram, Akshay Bhardwaj, Amit Kumar. Thermal Power Plant Modelling with Fault Coverage Stochastically
    45 -- 57George Lucas Dias, Ricardo Rodrigues Magalhães, Danton Diego Ferreira, Felipe Augusto Vitoriano. The Use of a Robotic Arm for Displacement Measurements in a Cantilever beam

    Volume 6, Issue 2

    1 -- 22Nupur Goyal, Ajay Kaushik, Mangey Ram. Automotive Water Cooling System Analysis Subject to Time Dependence and Failure Issues
    23 -- 40Ganzi Suresh, K. L. Narayana. A Review on Fabricating Procedures in Rapid Prototyping
    41 -- 50Apip Amrullah. Gasoline and Synthetic Fuel from Plastic Waste: Study for Engine Performance
    51 -- 66Mohd Idris Shah Ismail, Yasuhiro Okamoto, Akira Okada. Thermo-Mechanical Analysis on Thermal Deformation of Thin Stainless Steel in Laser Micro-Welding

    Volume 6, Issue 1

    1 -- 13Nikolaos E. Karkalos, Angelos P. Markopoulos, Dimitrios E. Manolakos. Cutting Speed in Nano-Cutting as MD Modelling Parameter
    14 -- 50Prasanna Gadhari, Prasanta Sahoo. Electroless Nickel-Phosphorus Composite Coatings: A Review
    51 -- 61Ashwani Kumar, Pravin P. Patil. FEA Simulation Based Performance Study of Multi Speed Transmission Gearbox
    62 -- 76Muhammad Khan, Nizar Ullah Khan, Muhammad Junaid Aziz, Hafiz Kaleem Ullah, Muhammad Ali Shahid. Improvement in Power Efficiency of Injection Molding Machine by Reduction in Plasticization Losses
    runs on